JetCat P60SE Turebine Engine

JetCat P60-SE Special Edition Turbine complete with starter includes:

The new design of the P60-SE incorporates an optimized compressor/diffusor-system, resulting in higher engine performance and reliability. The engine follows throttle commands almost without delay. 

The P-60 is capable of kerostart with external kero plug "not included".

Includes:

• Jet-tronic ECU (fuel control electronics)
• GSU (Display and Programmer)
• LED I/O board
• Miniature fuel pump
• Electronic starting gas valve
• Electronic Fuel valve
• Fuel tubing, tubing connector set, filters, and cable set
• 2 cell, 2500mA LiPoly battery pack
• Starting gas tank
• Turbine mounting clamp, RamTec compatible
• Detailed instruction manual

Specs:

• Thrust: 13 LB @ 165,000 RPM
• Weight: 1.87 LB, incl. starter
• Diameter: 3.25 inches
• RPM Range: 50,000 - 165,000
• Exhaust gas temp.: 580°C -690°C
• Fuel consumption: 8 oz per/min at full power
• Fuel: Jet A1, 1-K kerosene
• Lubrication: approximately 5% synthetic turbine oil in the fuel
• Maintenance interval: 25 hours