JetCat P200-RX

JetCat P200-RX

P200-RX Turbine Engine, 50,6 lbs Thrust, by JetCat

JetCat P-200-RX turbine comes complete with HEAVY DUTY starter and includes: Jet-tronic ECU (fuel control electronics) GSU (Display and Programmer) LED I/O board Miniature fuel pump Electronic starting gas valve Electronic Fuel valve Fuel tubing, tubing connector set, filters, and cable set 2 cell, 3300mA LiPoly battery pack Starting gas tank Turbine mounting clamp Detailed instruction manual Internal kerosene starting plug for single fuel operation. Fast startup!

• Thrust: 50,6 lbs @ 112,000 RPM
• Weight: 5.53 lb (2510g)
• Diameter: 5.12 inches (130 mm)
• RPM Range: 33,000 - 112,000 RPM
• Exhaust gas temp.: MAX 750°C
• Fuel consumption: 25 oz per/min at full power
• Fuel: Jet A1, 1-K kerosene
• Lubrication: approximately 5% synthetic Oil in the fuel
• Maintenance interval: 50 hours

Now Includes the ECU V10.0

The completely redesigned V10.0 ECU is three times smaller than the V6.0 ECU, yet has all its proven capabilities and more at a weight of only 26g!

The updated ECU comprises a high speed digital power bus for control and power supply of all engine peripherals (e.g. engine, fuel pump, solenoids, smoke pump, lighting systems, etc. ) with a minimum of wiring connections.

An on board precision pressure and ambient temperature sensor allows for optimum engine control, independent to environmental conditions.

Includes JetCat Mini-GSU

The JetCat Mini-GSU is an optional miniature Ground Support Unit (GSU). It comprises a 2x16 character alphanumeric backlit LCD display and 10 control keys.

Function wise it can be used as a 100% replacement for our normal GSU. Its small form factor and weight makes it ideally suited for permanent installation in the model.

Connection to ECU`s up to Version 6.0 is via a 8-pin miniature flatcable connector directly to the LED-I/O interface. Connection to ECUs from Version 10.0 is via a 6-pin miniature flatcable directly to the ECU or the LED-I/O interface or 8-pin flat cable to JetCat I/O-interface with charging option.

This New generation single shaft Turbine is equiped with a radial compressor ,diffusor , combution chamber , turbine and Exhaust nose.

RX will say, Full digital buss system intergated fuel valve ,Fuel pump,  intergrated power bus for a single connection to ECU V10.0 , only one correction for the fuel line , intergated Kero start and a starte

Parcel Content:
*  Turbine
*  Electronic control unit (ECU)
*  Ground service unit (GSU)
*  Fuel pump
*  Electronic start valve
*  Electronic fuel valve
*  Fuel tube -connectors- filters- cabels
*  Ni-cad battery 1250 mAh
*  Turbine mount
*   instruction manual