JetCat P180-NX Micro Turbine Engine ,Thrust 175 N ( 17,5 Kg)

JetCat P180-NX Micro Turbin Engine ,

Thrust 175 N ( 17,5 Kg)

This turbines the last design in the P180 turbines, has an integrated

Fuel pump , a brushless starter motor which can be used also as a generator.

The P180 NX has an integrated charge system which with the generator charge the turbine battery.

As option there is a JetCat BMS-system available for charging the battery's for the receiver and servo's

For the rest the turbine is the same as the P180-RXi as written below

• Internal kerosene start
• Internal EGT sensor
• Internal solenoids, only one fuel connection to the engine
• New “Bus-system” fuel pump
• Single wiring connection from ECU to engine
• New miniature/lightweight ECU V10.0
• Battery: 3-cell LiFe (e.g. A123)

This new design of the P180-RXi incorporates an optimized compressor/diffuser system, resulting in higher engine performance and reliability.

The engine follows throttle commands almost without delay. New ECU V10.0

The completely redesigned V10.0 ECU is three times smaller than the V6.0 ECU, yet has all its proven capabilities and more at a weight of only 26g.

The new ECU comprises a high speed digital power bus for control and power supply of all engine peripherals (e.g. engine, fuel pump, solenoids, smoke pump, lighting systems, etc. ) with a minimum of wiring connections.

An on board precision pressure and ambient temperature sensor allows for optimum engine control, independent to environmental conditions

• Thrust: 39.34 LB , 17,5 Kg@ 125,000 RPM
• Weight:   3.76LB ,1710 gram incl. start automatic
• Diameter:   4.41 inches , 112 mm
• Length: 13 inches, 330 mm
• RPM Range:  33,000 - 125,000
• Exhaust gas temperature:   730°C
• Fuel consumption:   20.63 oz per/min, 610ml/min. at full power
• Fuel:   Jet A1, 1-K kerosene , petroleum
• Lubrication:   approximately 5% synthetic turbine oil
• Maintenance interval 50 hrs